For simplicity, perhaps a slow-blow fuse of the proper rating would work.Īs for the sensor, nothing fancy is needed here since you could easily create your own using a photo cell and resistor (I'm talking 'cheap').Īs for the motor something under 500mA, around 2300 rpm or so (Because arduino can only provide up2 50mA current). It may not be so simple since you're gonna have to find a way to shut down the drive if there's a jam. Otherwise you may waste time, effort and money on electronics to drive a device that doesn't work. So don't even worry about that part until you've got the blinds working. In line with zoomkat's comments, the main obstacle in this project is the mechanics since controlling the project with an Arduino is very simple. Serial.begin(57600) //init Serail band rateīuff = Wire.receive() // receive one byte Int BH1750address = 0x23 //setting i2c address Here the current code I used for 1 sensor (from DFrobot): #include //BH1750 IIC Mode Please give me some reference to change the address? I don't understand, how to using it in multiple I2C address/sensor. Hi, I'm currently working on BH1750 too, Light_Sensor_SKU_SEN0097_-DFRobot
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |